| 价格 | 面议 |
| 发货 | 江苏付款后3天内 |
| 该产品库存不足 |
| 牌号 Type |
粘度 Viscosity Pa.s |
胶凝时间 Gel Time min |
固体含量 Solid Content % |
特性与用途 Performance & Applications |
| 196 | 0.60-1.2 | 6-18 | 63-70 | 邻苯型通用树脂，通过船级社认证，强度及刚性好，耐冲击。适用于普通模具。 Orthophthalic general purpose resin, good strength and flame retardant, authenticated by China Classification Society, good strength and toughness, shock resistance, suitable for common mold. |
| 198 | 0.55-1.0 | 6-15 | 60-67 | 邻苯型耐热树脂，强度及刚性好。适用于有中等耐热要求的模具。 Orthophthalic heat resistance resin, good strength and rigidity, suitable for mold required medium heat resistance. |
| 199 | 0.35-0.65 | 10-15 | 58-64 | 间苯型耐热树脂，强度及刚性好。适用于有较高耐热要求的模具。 Isophthalic heat resistance resin, good strength and rigidity, suitable for mold, required higher heat resistance. |
| 946 | 0.35-0.50 | 5-12 | 61-67 | DCPD型树脂，温峰低，收缩小，强度和刚性好，吸水率低。适用于高强度、低收缩的模具。 DCPD type resin, lower peak of exotherm temperature, small shrinkage, good strength and rigidity, lower water absorption, suitable for mold required high strength and low shrinkage. |
| VER-2 | 0.30-0.50 | 20-30 | 55-61 | 双酚A型环氧乙烯基酯树脂，高强度耐冲击，性能优异。适用于性能要求高的模具。 Bisphenol A vinyl resin, high strength, shock resistance, good property, suitable for mold required high performance. |
| 946PT-3 | 0.30-0.50 | 10-22 | 10-22 61-67 | DCPD型预促触变树脂，抗流挂，浸润和消泡性好，强度高，收缩小。适用于高强度、低收缩的模具。 DCPD pre-promoted thixotropic resin, anti-sagging, good wetting and defoaming, high strength, small shrinkage, suitable for mold required high strength and low shrinkage. |
0询价面议
0询价面议
0询价面议
0询价面议
0询价面议
0询价面议
0询价面议
0询价面议
0询价面议
0询价面议
